How to Remove and Install Quick Release Spring Bars

This guide shows you how to remove and install quick release spring bars in just a few simple steps.

How to install quick release spring bars

1. Line up the spring bar with the notches on the watch case.
2. Insert one end of the spring bar into the notch on one side of the watch case.
3. Press down on the other end of the spring bar, compressing the spring.
4. Insert the other end of the spring bar into the notch on the opposite side of the watch case.
5. Release the pressure on the spring bar, allowing it to expand and secure the strap to the watch case.

How to remove quick release spring bars

1. Locate the small pin on the underside of the watch strap near the watch case.
2. Use your fingernail or a small tool to press down on the pin.
3. While pressing down on the pin, gently pull the strap away from the watch case.
4. The spring bar should release from the watch case, allowing you to remove the strap.

A video on installing and removing quick release spring bars

For a visual demonstration, check out the video below that shows you how to insert and remove quick-release spring bars.

Conclusion

In conclusion, quick release spring bars are a convenient and easy way to change the strap of your watch without the need for any tools. By following the steps outlined in this article, you can easily remove and insert quick release spring bars into your watch strap.

How to Change Watch Strap In 5 Minutes